Physical Layer Model On the receive side of Physical Layer the incoming serial data from PCI Express link is converted into its original format such that parallel data and the added frames are removed and the packets are send back to Data Link Layer.
The Data Link Layer acts as an intermediate Layer between Transaction and Physical Layer, nothing but a Gate Keeper. The main responsibility of Data Link Layer is Error detection and correction.
Data Link Layer Model
Data Link Layer takes the TLP-Transaction Layer Packet from transmit side of the Transaction Layer. Here 12 bit sequence Number is added in front of the TLP and LCRC-Link CRC checker to the end.
Data Link Layer then forwards the applied TLP to the Physical Layer transmit side. On the receive side of Data Link Layer, accepts the packet from Physical Layer and checks the Sequence Number and LCRC with the applied Sequence Number and LCRC. If the Sequence Number/LCRC matches then the TLP are moved to receive side of Transaction Layer and generates ACK (Acknowledgement) signal. If there is any mismatches/error detects in Sequence Number or LCRC then Data Link Layer does not send the “Invalid or Bad” TLP to receive side of Transaction Layer, instead it generates NAK (Negative Acknowledgement). Data Link Layer now starts “Retry” attempts to send the valid TLP to Transaction Layer.
The Upper Layer of the architecture is the Transaction Layer. The main responsible of this layer is to begin the process of turning request or completion from device core into PCI Express transactions.
On the Transmit side, the transaction layer receives request or completion data from the core, and turns that information into out going PCI Express transaction.
On the Receive side the transaction layer accepts the incoming PCI Express transactions from its Data Link Layer.
Transaction Layer uses TLP-Transaction Layer Packet to communicate request and complete data into other PCI Express devices. Each TLP has a Header to identify the type of transaction. The Transaction Layer request device generates the TLP and completion device consumes the TLP. Transaction Layer has several other operations which include “Flow Control” and “Power Management”.
Header identifies the information for the transaction (types). PCI Express architecture defines four transaction types.
· Memory Transaction
· I/O Transaction
· Configuration Transaction
· Message Transaction
Where as DLP and ECRC (End to End CRC) are optional.
PCI Express Layering Diagram Model
PCI Express technology, there is only one signaling rate defined, which provides an effective 2.5 Gigabits/second/Lane/direction of raw bandwidth. The data rate is expected to increase with technology advances in the future.
PCI Express configuration has serial links: X1, X2, X4, X8, X12, X16 and X32. An X1 configuration has a single serial path of Transmit and Receive. Likewise X2 configurations have two serial paths of Transmit and Receive. The serial links pronounced as or read as ” by one “- X1 and “by two”-X2 and so on.
When look back to history we can find so many advancement in technology day today life. When refer to the technology, can find lot of development between every stage. In communication and computer sector the growth is drastic change, people can communicate any where in the world in few seconds because of technical advancement. There are certain times in the evolution of Technology for every generation. Because of technology revolution a new input/output architecture, PCI Express allows computer to process far beyond the limit when compared with the existing technology. The term PCI - Peripheral Component Interconnect.PCI Express is the third generation I/O interconnects.PCI Express communicate the devices simultaneously by implementing dual unidirectional paths, this makes the protocol high speed and low voltage.The three main technologies,
· PCI
· PCI- X (Derivative of PCI)
· PCI- Express
PCI-X is not the abbreviation of PCI Express. PCI-X evolved from PCI.
